PrefaceChapter 1: Steel and Alloys, Metalworking TechnologiesInvestigation of the Behavior of Surface Roughness Suppression Orientation on the Inner Surface of Metal Microtubes Using Crystal Plasticity Finite Element MethodReduction of Surface Cracking for Al-4.6%Mg Strips Cast Surface Using an Unequal-Diameter Twin-Roll Caster by Back-Dam Plate with LipInvestigation into Stress Relaxation and Creep Rate of C47200 Copper AlloyEnhanced Microhardness and Corrosion Performance of Additively Manufactured Inconel 718 Specimens through Nanostructuring by Severe Plastic DeformationProcessing Maps and Optimized Plastic Behavior Model of TC4 Titanium Alloy Diffusion Bonded Joint at α+β Region TemperaturesEffect of Roll Diameter on Temperature of Aluminum Alloy Strip during Casting Using a Vertical Type High Speed Twin Roll CasterHigh Efficiency Milling of Inconel 625 Alloy (Effect of Cutting Condition on Tool Life)Mechanical and Microstructural Behavior of Sintered NiAl-Based High Entropy AlloyThe Influence of Cow’s Bone Calcium Concentration on the Mechanical Characteristics of a Mg-Al AlloyPhase Prediction, Microstructure, and Microhardness of Sintered Nickel-Based SuperalloyProcess Optimization of Spark Plasma Sintered Parameters for Ti-Al-Cr-Nb-Ni-Cu-Co High Entropy Alloy by Response Surface MethodologyChapter 2: Preparation and Properties of Building MaterialsDurability Studies of Conventional Cement Concrete and Geopolymer ConcreteEffect of Particle Size and Molarity of Hardening Solution on the Mechanical Properties of New Geopolymeric Mortars Manufactured from Mine TailingsSilica Fume-Red Mud Based Geopolymer Stabilized Organic SoilCorrosion Resistance and Thermal Stability Enhancement of Green Layered Clay/Epoxy CoatingUse of Domestic Waste Polyethylene as a Bitumen Modifier in Bituminous Pavement ApplicationsIdentification of Waste Potential from Maritime Activity - Incorporating Polyethylene Cables into Building Construction