PrefaceChapter 1: Structural Metals ProcessingSurface Roughness Improvement of PBF-LB Manufactured 316L with Dry ElectropolishingPrediction of Melt Pool Dimension, Porosity Generation and Thermal Behavior of Ti-6Al-4V during Powder Bed Fusion at Various Scan Speeds and Laser PowersImprovement of Safety and Reliability of SCM440 Steel with Induction HardeningChapter 2: Functional MaterialsThermoelectric Properties of Annealed Bilayer SnSe/PbTe and SnSe/PbSe Thin Films by Thermal Evaporation MethodStructural Aspects of Soft Ferromagnetic Mg-Zn Based Intermetallics Prepared by Die CastingChapter 3: Environmental SustainabilityDetermination of Air Pollutants Removal Efficiency by Wet Packed Scrubber SystemGroundwater Purification Using Bio-Sand Filter Modified with Iron Oxide-Coated Sand and Activated CarbonGrowth in the Worldwide Stock of E-Mobility Vehicles (by Technology and by Transport Mode) and the Worldwide Stock of Hydrogen Refueling Stations and Electric Charging Points between 2020 and 2022Chapter 4: Materials and Technologies in ConstructionDevelopment of Recurrent Neural Network Model for Bridge Effect Detection by Various Fibers Incorporated in Fiber-Reinforced ConcreteInternational Experience and Prospects for the 3D Concrete Printing DevelopmentBond Strength of Steel Bars in Sustainable Concrete Made with Recycled AggregatesEffect of Short-Term Outdoor Exposure on Fatigue Property of Japanese Cedar under Cyclic Loading In Situ Large Scale Direct Shear Test for Evaluating Compaction Work of Random Material: Case of Construction Failure in an Indonesia DamCharacterization and Evaluation of Asphalt Mixtures for Cycle Paths with Cellulose Fiber Obtained from Non-Toxic Sanitary WasteInfluence of Chopped Carbon Fibers Addition with Different Curing Methods on the Mechanical Properties of Cement Mortar PerformanceCalculation and Application of Ultimate Lateral Friction Resistance of Concrete Piles under Different Soil Layer MaterialsCircular Economy: Upcycling Wood Byproducts from the Azores into Building Insulation MaterialEffect of Three Surface Protectors on Surface Cracking and Discoloration of Pinus Radiata Wood, after Accelerated Aging by UV Rays and HumidityChapter 5: Strength of MaterialsThe Analysis of Vibration Resistance of the Shape and Braided Laminated Manufactured Structure Using Taguchi MethodBiomechanical Effect of Bone Variables and Implant Position on Femoral Damage Mechanism in Total Hip Arthroplasty